XCP is a common requirement from automotive OEMs. I’ve found that Implementing XCP-on-CAN for a C2000 device is far from straightforward and there doesn’t seem to be much information publicly ...

I wondered which parameters I can change (except parameters of my motor) during my own tuning process when using hvkit with F28069M ISO Control Card? When I was ...

Hello I have a question about changes in PRU FW between SDK Linux RT version 8.2 and 9.1. When I connect IDK PRU ICSSG port to NIC which starts sending frames after linkUp. There is different behavior ...

I am currently using Hercules_Ethernet_Bootloader, I am using CCS 9.1 . When using Uniflash to burn Build-TMS570LC43x-tftpBoot.out, an error is reported. How can I ...

I need some details/clarifications: - looks like txQueue and rxQueue are static arrays defined in both int_comm_drv.c and meter_comm_drv.c? - Which .c file does the code that is shown above correspond ...

I am working with adding INA3221 in my schematic. I am wondering about the address pin. There is only one address pin Ao. The pin Ao can be attached to GND, VS, SDA, or SCL. Does it means only four ...

Texas Instruments (TI) Sensors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search sensors IC content or ask ...

We are building the Ti Yocto Linux but everytime it gives an error in the following package, gdk-pixbuf_2.42.10. This is the command that we use for the setup: ./oe ...

Texas Instruments (TI) Bluetooth® support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search Bluetooth® IC content or ...

Does TPD6S300A have zSBUTermination(≥950kohm) specified in USB Type-C Specification internally? Our product implements 2Mohm as zSBUTermination according to DP Alt Mode standard # 3.9.1.1. When ...

Yes, this number is with PFM enabled. We do not have this number with PFM disabled. If quiescent current is an important measure for the customer, PFM should be enabled. In addition, the quiescent ...

On our custom board based on AM6442ASDGHAALV we try to boot from SD card but booting is interrupted by error: SD card: no support for card's volts. This message is ...